Tsukayu Quick Release Mounting System |
| Installation Guide of quick release hard saddlebags for VTX in PDF format (Dowdload Here) |
 |
Tsukayu Quick Release Mounting System
Tsukayu quick release mounting
brackets are made of very strong, thick, chrome quality stainless steel.
They are impossible to be bended in normal use, are the main element in
Tsukayu mounting system. Free of vibration, life-long durability.
This quick release mounting system work on hard saddlebags for VTX currently. With these mounting
brackets, you may remove the bags in just 2-3 seconds. Your
hardbags will be pre-drilled mounting holes and stick very close to
your fender.
All
mounting brackets, bolts and metal washers are made of chrome quality
stainless steel, they are very durable, very strong and reliable. |
| Tsukayu
quick release mounting system is that they fit very closely to your fender
Comparison
with mounting system of other leading brand
: |
|
Tsukayu Quick Release Mounting
System |
Other brand |
|
Warning:
- Do not exceed maximum recommended load of 20 lbs.
- Perform periodic check every week.
- Improper loading and set up may lead to loss of control
of motorcycle and accidence.
- Installation is recommended to be performed by professionals. All commonly accepted shop safety precautions
should be understood and followed when attempting this installation. Refer to Factory service manuals for
your model for information before attempting to attach any accessory to a motorcycle. It is the owners responsibility
to understand and accept responsibility for installation and use of this accessory. If you are unsure of any
part of the installation, stop and verify the safety of what you are doing. |
 |
Installation
guide
Install the quick detachable brackets-part A on the fender struts with supplied bolts and spacers, don't tighten the bolts yet and leave them adjustable with hands |
 |
Quick detachable brackets-part B come already installed on the hardbags |
|
Put the hardbags on, adjust the quick detachable brackets-part A, there is only one position that allow you to put the bags on |
 |
You must push the hardbag toward the fender strut, and the handles have to be up straight in order to put the handles ON and OFF. Without doing both, your hardbags cannot be taken off or fall off even the handle is unlatched or loosen. |
 |
Latched |
 |
Put on the quick detachable bracket-part C ( the handles), and latch. |
 |
Tighten the fender strut bolts with 17mm and 14mm wrench, and it is now ready for use and can be taken on and off in less than 10 seconds |
